15192 Autoloader ALE: End of bay <bay#> detection tab not found, picker may be stuck. Platesetter_3244 check bay sensor using "picker" or "sat stat pkr". check that bay tab is not damaged. check bay locations. (cal bay f/w 2.25) Replace H/A board / cables. Check for PY stalling / driver problems. Resume. If problem persists, reset machine, remove plates as required during start up. Y axis stopped because distance (btsy) was moved but never found tab. ../nvs/bay_cal_loc.xmlNVS: bay loc ../nvs/alpos_cal_btsy.xmlNVS: alpos btsy ##Comand: cal ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:55 2008 PST http://techplanet.creo.com/output/computer_to_plate/platesetter_3244/content/troubleshooting/15192.htmOther: Troubleshooting information